View Single Post
Old 08-09-2012, 09:56 AM   #148
TINK OP
Studly Adventurer
 
Joined: Nov 2007
Location: So Cal
Oddometer: 668
TO DO List

Just a few of the things I need to do:

PROJECT-S TO DO List

NOTE: Photos, take lots of photos of wiring before disassembly!
Clean wiring harness
Lub electrical connectors
ID connector #ís / wire color and note on wiring diagram
Label wires with connector #
Move ign switch into headlamp
Paint (brush) top frame tubes where brake master fluid damage

Fabricate seat mounts
Paint (brush) seat mounts

Pull swing arm (pull pumpkin first)
Pull sub frame
Paint (Krylon) swing arm (off the bike)
Paint (Krylon) sub frame (off the bike)
Paint (Krylon) rear frame (on the bike, mask off engine, etc.)

Pull trans (not all the way out, just enough to access clutch splins)
Lub clutch splines with Honda Moly 60

Paint (brush) front master
Rebuild front master

Rear caliper diassemble/inspect
Rear master diassemble/inspect

Ya, I should be able to get all this done this weekend, ...well, maybe not
TINK is offline   Reply With Quote