View Single Post
Old 08-18-2012, 08:38 PM   #163
TINK OP
Studly Adventurer
 
Joined: Nov 2007
Location: So Cal
Oddometer: 621
Huston, we have ignition

Moved the ignition switch into the head lamp housing.
Had to cut off the rubber connector insulators to get them to pass through the hole in the headlamp, then heat shrink tube them back on once all the connectors were on this inside of the housing. Went ahead and labeled the wires while I was there so I would be sure to get them back on the right connections.


TINK
TINK is offline   Reply With Quote