View Single Post
Old 09-23-2012, 12:16 PM   #4
JRWooden
Beastly Adventurer
 
Joined: Jul 2008
Location: The great state of confusion
Oddometer: 4,110
Quote:
Originally Posted by Kiwirich View Post
Hi Third Uncle,

That's pretty crazy bearing consumption.I guess that installation issues are out of the question along with Lubrication.

Have you considered Electrical Earthing.?

I'm just wondering if there is some low current circuit passing through the bearings. This will effectively cause Arcs across the faces & over time it will destroy the hardening.

It took me a change of Handlebars and 4 sets of bearings to find this issue on my 1150 GSA. The symptoms were similar and it was a nick in the loom on the Right hand side.............

Richard
Wow ... good on ya!
I don't know that I EVER would have tracked that down, but it is now etched into a couple of synapses for good ...
I hope....
JRWooden is offline   Reply With Quote