View Single Post
Old 10-02-2012, 01:44 PM   #15
Ghilli OP
super n00b
 
Ghilli's Avatar
 
Joined: Sep 2012
Location: Sea Point, Cape Town
Oddometer: 21
Quote:
Originally Posted by Clay Spinner View Post
Nice post... just a question... how does one measure the wear limit?
In the back of the manual it says that the max permitted wear on the drum is 201.5mm, that is the inner diameter of the hub which I measured with a large vernier. If you look closely you can see its a steel band that is cast inside the aluminium hub.

Only problem is, this is the data for a 4 bolt hub and not the older 3 bolt, not sure if it is the same for both models.
Ghilli is offline   Reply With Quote