View Single Post
Old 10-05-2012, 02:09 PM   #14
dylanewilliams OP
Adventurer
 
Joined: Oct 2012
Location: San Diego CA and Richmond CA
Oddometer: 15
I found out which is the cat code plug, (it's the pink relay on my bike), pulled it and started the bike. Immediately the bike wanted to run at 2-3K rpm, very roughly, and then died. I reinstalled the CCP and got the same result when starting it, high rough rpm then death.

I took off the belt and pulley and think I found the culprit for the screeching, the spring steel tab which holds the HES wire at the rubber boot at the top of the engine case was broken and rattling around with the belt, so that narrows down the symptoms at least.

dylanewilliams screwed with this post 10-05-2012 at 02:30 PM
dylanewilliams is offline   Reply With Quote