View Single Post
Old 10-05-2012, 09:45 PM   #83
Bill-66
Hencho in Kansas
 
Bill-66's Avatar
 
Joined: Sep 2009
Location: The Northwet..
Oddometer: 7,456
Question for those that have done it...figuring it would be a good thing to know.I was looking at aftermarket grip heaters the other day at the local dirt bike shop...

They all have three wires..(Symtec)..the BMW only runs two..if you are soldering them in, which two wires?? Or do you have to search out 2 wire ones..? What about the resistor most seem to use? Can you just leave that out if wiring into factory wires?

Sorry, I'm weak in electrical..if you wanna tear the motor down, no problem..
__________________
"Ignorance is a powerful tool when applied at just the right time..sometimes even surpassing knowledge.." EJ Potter
Bill-66 is offline   Reply With Quote