View Single Post
Old 10-07-2012, 05:23 PM   #47
ebrabaek OP
Beastly Adventurer
 
Joined: Jan 2010
Location: Grand Valley, Colorado
Oddometer: 4,671
So.... I took a stick on a 90 deg. angle to the tire....at the point of contact with the lower fender.... There was 2 inches to the beak..... so in theory to yield the same protection....beak goes forward two inches. Beak is now off, and release agent is applied. The simplest way is to make a print of the original beak, and use the front and rear part, so you get an accurate press of the mounting of the beak, and the forward section where the stock black plastic will bolt right on. This way it is vastly different than the stock, and thus no copyright infringement issues, if I decide to make a mould, in case any one are interested....



So it has begun.....
__________________


Erling
ebrabaek is offline   Reply With Quote