View Single Post
Old 10-08-2012, 08:24 AM   #55
ebrabaek OP
Beastly Adventurer
Joined: Jan 2010
Location: Grand Valley, Colorado
Oddometer: 4,873
As this piece is going to be a throw away after the first cast is made, I tried to use a bit of fiberglass , but was reminded of how bad it conforms, as compared to the CF. This beak has some crazy angles, but I am hoping that I cam make this without vacuum moulding. So far so good. This will now set, and then the next two layers for a total of three will be laid.


ebrabaek is offline   Reply With Quote