View Single Post
Old 10-10-2012, 01:50 PM   #85
Gnarly Adventurer
tommyvdv's Avatar
Joined: Mar 2011
Location: Belgium
Oddometer: 420
Originally Posted by VEGASGSA View Post
Question for those that have done it...figuring it would be a good thing to know.I was looking at aftermarket grip heaters the other day at the local dirt bike shop...

They all have three wires..(Symtec)..the BMW only runs two..if you are soldering them in, which two wires?? Or do you have to search out 2 wire ones..? What about the resistor most seem to use? Can you just leave that out if wiring into factory wires?

Sorry, I'm weak in electrical..if you wanna tear the motor down, no problem..
i installed these

two wires. only hassle was connecting the wire. but in hindsight I should've used smaller crimps. will redo it one of these days
tommyvdv is offline   Reply With Quote