Thread: airhead noob
View Single Post
Old 10-15-2012, 05:20 PM   #41
scout18 OP
Studly Adventurer
 
scout18's Avatar
 
Joined: Jul 2008
Location: Portland Oregon
Oddometer: 921
Well first things first. I gotta get that wheel in and the bearing preload set. Then we chase the smoke.

Ok So I put the wheel all back together and greased everything like it said to. I ran the nut tight as instructed to check the preload and there was the tiniest bit of movement when I did the shake test. I took out the axle and measured the wedding ring spacer. It was .271" thick. So I lapped it on a glass plate with 220 grit sandpaper to .2695". put it back in and I had less movement during the run up but enough to pull it back out for a little more lapping finishing it with 600 grit for a finished thickness of .268". In it went preload is set to as movement free as I can stand at this point. Now to adjust that rear brake actuator arm back a spline. Then a carb look see and rebuild.
__________________
Alis Volat Propiis


scout18 screwed with this post 10-15-2012 at 10:27 PM
scout18 is offline   Reply With Quote