View Single Post
Old 10-17-2012, 09:23 AM   #32
guns_equal_freedom
Beastly Adventurer
 
Joined: Jul 2007
Oddometer: 5,437
I also bought a Hyde Racing plastic skid plate.

What I did with the front mount was to figure out where it sits, then I built up 8 layers of duct tape below where it sits on both frame rails and then used a small bit of duct tape to hold it in place.

I used a long bolt on one side to locate the hole and get the bracket in place, then I use a smaller bolt on the other side, then I go back to the first hole and use the stock bolt and bolt it up, the do the same with the other hole.

It's worked great so far for me.
guns_equal_freedom is offline   Reply With Quote