View Single Post
Old 10-18-2012, 04:34 PM   #14
CosentinoEngineering OP
Gnarly Adventurer
 
Joined: Oct 2010
Location: NYC
Oddometer: 184
Throttle springs are in progress. I tried to wind some samples on my simple spring winder but couldn't get an acceptable result so I ordered a few samples in different wire sizes from the vendor that makes the springs for my vintage fork upgrade kit.

The choke is also in progrsss, the aim is to make something that uses the stock KTM clutch master cylinder choke lever and maybe the stock KTM choke cable too. It may need some carb machining so would require the carbs to be sent to me. I'll try to avoid that but it may be unavoidable.
__________________
Chris
moto2-usa.blogspot.com
Check out my products 10% off for ADV rider members
CosentinoEngineering is offline   Reply With Quote