View Single Post
Old 10-19-2012, 01:00 PM   #81
disston's Avatar
Joined: Mar 2011
Location: Silver Spring, Md
Oddometer: 10,210
I am right now half way through cutting the butterfly shaft out of the right carb with a file. I don't have any good hack saw blades. I have a hole saw kit I thought of using but it's much too crude to hold inside the throttle bore and cut the brass plate and shaft with out causing a bunch of collateral damage. The heads of the screws were buggered so I have to cut the dang thing out in two places so it will all come out. I hope to finish this part of this project tonight.

Going to try running the stock jets Bill.
Never memorize something you can look up.
---Albert Einstein

Pay your debt, piratejohn.
disston is offline   Reply With Quote