View Single Post
Old 10-22-2012, 04:21 PM   #13
ebrabaek OP
Beastly Adventurer
 
Joined: Jan 2010
Location: El Paso,NM
Oddometer: 4,455
Quote:
Originally Posted by runnin4melife View Post
Erling, This may be the route that I go as well. I pulled out the KLX forkguards and it will be a lot of work to try and mate anything (heat gun and forming). I might also make a cast using the two portions though as I like the upper plastic styling but need the lower bolt pattern. Either way it is on hold for the moment because it is a nice week and I finished with the fender mount today.
Yeppers...... Just bear in mind, that those nice lines, can be a bear to conform the fabric over...... It sure was a breeze to mould these. They don't look fancy or anything, but as with most of my pieces..... they serves the purpose.
__________________


Erling
ebrabaek is offline   Reply With Quote