Originally Posted by texzen
I'm just going to assume the little box is filled with resistors that will bias my inlet air temperature. A simple jumper bar placement will determine which resistor is in the circuit. I hope the resisters are sized properly for the proper correction values and rated to handle the wattage incurred. (The ones from Denmark are not). I'll assume all liability for what biasing the air inlet temperature does.
I just want to know when I could get it.
Thermistors, yes. And they are more than rated for the job. Here's a link to a series of pics that show what's on the inside
Regarding placing an order, take a look at the post above from stan23. Send him a PM if it looks good to you.