View Single Post
Old 10-23-2012, 04:53 AM   #561
Poolside OP
Syndicated
 
Poolside's Avatar
 
Joined: Apr 2003
Location: Long Beach, CA
Oddometer: 11,850
Quote:
Originally Posted by texzen View Post

I'm just going to assume the little box is filled with resistors that will bias my inlet air temperature. A simple jumper bar placement will determine which resistor is in the circuit. I hope the resisters are sized properly for the proper correction values and rated to handle the wattage incurred. (The ones from Denmark are not). I'll assume all liability for what biasing the air inlet temperature does.

I just want to know when I could get it.
Thermistors, yes. And they are more than rated for the job. Here's a link to a series of pics that show what's on the inside.

Regarding placing an order, take a look at the post above from stan23. Send him a PM if it looks good to you.


__________________

IICE Air Hotrod your GS  Fuel Injection  Tech Info  Buy  Order List  Installation
Poolside is offline   Reply With Quote