View Single Post
Old 10-23-2012, 07:40 AM   #21
kbroderick
Beastly Adventurer
 
Joined: May 2009
Location: Red Lodge, Montana
Oddometer: 1,041
Quote:
Originally Posted by vintagerider View Post
If you remove the pulley be sure to use adhesive between the die Glocke (the bell) and the pulley. That step is not in the pdf but is in the oem service manual. Pay real close attention to the locating tab. PP have ruined brand new HES units from incorrect assembly.
Any notion of which adhesive I should be using? Loctite? Epoxy? Elmer's glue?
kbroderick is offline   Reply With Quote