View Single Post
Old 10-24-2012, 02:41 PM   #88
Beastly Adventurer
Joined: Jan 2010
Location: Grand Valley, Colorado
Oddometer: 4,873
Nice.... I like the look and shape. I might eventually cut the outside, as such, but I wanted to leave this open, as to protect the top side of the sliders. Unless you use the HTE ( I don't recall seeing you buy that, then I think that you need 4 layers, as the hp is not as stiff..... Buy only you can judge that after casting..... You can always add that on the backside later......

ebrabaek is offline   Reply With Quote