View Single Post
Old 10-25-2012, 10:45 PM   #11
MJ Gurunathan OP
Joined: Apr 2008
Location: Singapore
Oddometer: 10
Pocket Milling

Hi Mike.

Thanks very much, I took this as a learning experience. It was fun and I learned a lot.

Originally Posted by MotorradMike View Post
Brilliant job MJ.
You hid this little tidbit quite well and I'm sure most of us missed the fact that you had access to all that equipment.

Question about the pocket milling if you don't mind.
Why didn't you simply bore the hole in preparation for tapping?
I didn't have a reamer that large! I had a couple of endmills lying around so I chose to pocket mill instead. The machine I was using had the canned cycle there so it was very easy to use.
MJ Gurunathan is offline   Reply With Quote