View Single Post
Old 10-26-2012, 01:33 PM   #1
Kenbike OP
Studly Adventurer
 
Joined: Jul 2009
Location: South of the big lake
Oddometer: 600
Pulling and reinstalling heads

I planning on pulling my heads and throttle bodies in 3 or 4 weeks and sending to Power Tripp for a port job and blueprint the throttle bodies. Will raise the compression ratio slightly and rework the heads to improve mid range punch. I will be removing and installing the heads my self. I assume it is not to bad and wanted to see if any one has pulled and reinstalled them with the engine still in the bike?
I will also will remove the exhaust header and have it coated to help reduce engine heat. I just can't swing the cost of selling my for $8000 and buying a new 1190 for $15000 and it still needing $2500 in farkles so this is my route.
Hopefully will pick up 7 to 10 hp and my Bazzaz auto tuen can remap for the increased flow.
Currently have a Moto Hooligan air box and RC8 intake trumpets with a Remus Roxx 2 into 1 system with out the baffle.
__________________
Current Bikes: 2012 Yamaha Tenere, 2010 Vespa 300 Super scooter ( hers), 2011 Blur 220i (his)
Kenbike is offline   Reply With Quote