View Single Post
Old 10-27-2012, 06:43 PM   #20
Zombie_Stomp
Aspiring human
 
Zombie_Stomp's Avatar
 
Joined: Jun 2007
Location: SE Portland/ Carrboroland NC
Oddometer: 2,231
Quote:
Originally Posted by LandsVW View Post
"From Clymer Honda XL/XR200-600 1978-1985 printed in December '85. Should be the same as '86 and up.

XL/XR 350-600cc torque specs"

Helpful, thanks! I noticed that the torque specs are just a little lower than the later bikes on several bolts, so that may save me problems with over tightening. I saw a picture somewhere on the XR600 forum that compared an old lower timing gear with a new timing gear. Anyone know where that link is?

Also, I have the case halves reassembled. I'm going to fit the cylinder, piston and head today and then check my timing chain like the earlier link suggested... If it seems off then I'll order a new set. I figure do that before I get too far along. The right side and chain can be assembled any time w/ the cylinder/head on.
I assume it test shifts ok?
__________________
1983 Toyota pickup: total overhaul, preservation-restoration in constant progress...
1987 Yamaha XT600 2KF (German)
STOLEN: RED XL600 in Portland

I do heavy-duty textile repair, upholstery, and design/manufacture bags.
Zombie_Stomp is offline   Reply With Quote