View Single Post
Old 10-30-2012, 02:06 PM   #2113
CaribouCases OP
Boulder CO
 
CaribouCases's Avatar
 
Joined: May 2004
Location: Adventure Rider & Aftermarket Systems Manufacturer
Oddometer: 1,200
Quote:
Originally Posted by reenmachine View Post
OK, what I was really wondering was if the cases I already have, which are drilled for my G650GS, will fit right onto the racks for the FZS 1000 Fazer. I think the answer is yes in theory, but there may be an interference with the exhaust.
You have it correct. The exhaust may not be a problem, but if it is you can drill new holes in the case and fill the old ones with JB Weld. It works suprisingly well at sealing old holes. Also, our latch brackets are bolted to the rear-most tube of the racks on the G650GS, so you will need to swap them over or buy a second set of them if you plan to use both bikes and one set of luggage.
__________________
Roger Pioszak, Caribou Luggage Systems.
Please see the beginning of the Pelican-Based Luggage Thread in the Vendor Forum .
www.cariboucases.com
Made in Boulder, Colorado USA
PH: 303-786-8947 Mon-Sat 8:00am-5:00pm Mountain Time Zone
CaribouCases is offline   Reply With Quote