Thread: Drive shaft
View Single Post
Old 11-01-2012, 04:46 PM   #1
kellymac530 OP
motorcycle addict
 
kellymac530's Avatar
 
Joined: Feb 2010
Location: so. cal.
Oddometer: 1,052
Drive shaft

I am looking at extending a swing arm on an R80G/S and I want to do the method of using 2 drive shafts with one weld rather than a splice with 2 welds.

Are the U-joint ends on all R60 R80 R90 R100 driveshafts the same size?

I have a line on a couple of shafts and don't want to waste my money if the U-joints are different
__________________
it is easier to ask for forgiveness than permission
kellymac530 is offline   Reply With Quote