View Single Post
Old 11-01-2012, 08:41 PM   #22
Kai Ju
Beastly Adventurer
 
Kai Ju's Avatar
 
Joined: Jul 2009
Location: So Cal
Oddometer: 1,772
When I made the shift linkage for my home made rear sets on my Beemer I bought 1/4" rod, carefully sanded it down on both ends to just under 6mm and ran my 6x1.0 mm die over it.

You only have to do one end, the other end is a slip fit inside the M/C

I found aluminum rod as well as steel at the local Ace hardware store.
Kai Ju is offline   Reply With Quote