View Single Post
Old 11-05-2012, 11:39 AM   #79
headtube
6 months of winter!
 
headtube's Avatar
 
Joined: Sep 2012
Location: Toronto
Oddometer: 212
Quote:
Originally Posted by Yachtie View Post
then backed off the mixture screw 2.5 Half turns, thats where it was pre removal.
Set your idle mix screw (1) turn out. 2.5 is too much. Start at one turn, then make "small" adjustments from this point to even out your idle sync.

Note: don't confuse the throttle stop screw with the mixture screw. Although both screws produce an idle of sorts. A good rule of thumb when setting the throttle stop screw is to screw this in until it touches the arm, (this arm is attached to your throttle cable/s) then turn it in one full turn. Adjust each side the same and set your idle from there making small adjustments.
headtube is offline   Reply With Quote