ADVrider - View Single Post - Clutch plates, replace with ZX-10

rossguzzi · 11-05-2012, 07:32 PM

I just finished inspecting and measuring plates and springs. All seem to be within specs. So thats good !
My problem seems to be creeping with clutch in. I will be getting bigger jet (the one in it has no number) and I see the hard rubber block under the slave is newish looking but the center hole looks skewed. May replace this.

Thanks for the other info. I have recorded it for future.

Cheers.

11-05-2012, 07:32 PM	#5
rossguzzi ^OP Gnarly Adventurer Joined: Oct 2012 Location: Bottom left hand side of OZ Oddometer: 262	I just finished inspecting and measuring plates and springs. All seem to be within specs. So thats good ! My problem seems to be creeping with clutch in. I will be getting bigger jet (the one in it has no number) and I see the hard rubber block under the slave is newish looking but the center hole looks skewed. May replace this. Thanks for the other info. I have recorded it for future. Cheers.