I currently have a waterproof switch to activate the low octane map on my bike instead of disconnecting the wires. Only problem is the only waterproof switch I could find was a push button. I can't tell when the thing is pushed or not because it resets to the same position.
I want to wire it to a Highway Dirt Bikes handle bar clamp set up so my questions are:
1) Are the HDB buttons set up so that it is very clear if the button has been pushed or not?
2) Is there a way to wire it so that when it is activated it lights up the small LEDs that you can get with the kit?
I know I
could just wire it so that I unplug the wire like stock, but what fun would that be?
