View Single Post
Old 11-08-2012, 07:12 AM   #377
The Toad OP
Let There Be Light
 
The Toad's Avatar
 
Joined: Oct 2007
Location: Location, Location.
Oddometer: 1,140
Quote:
Originally Posted by Dirtnadvil View Post
I was wondering if anyone could "shed some light" on a question I have about wiring the MM10 lights. I want to ditch the harnes if I don't need it. I already have an Eastern Beaver 3 circuit set up on my bike. Can I wire the lights straight into the EB set up and use just the on/ off switch or do I need the relay and the whole harness? Thanks
If I am reading the question right, you will need the relay/harness if you are going to use the switch that comes with the light kit. If you have your own switch (toggle or any SPST) then no, you do not need the harness.

Hope that answers the question

-Brian
__________________
MondoMotos - LED Auxiliary Light Kits - Tusk Panniers
RoadRUNNER Magazine - Blog
Ride Reports - Four Corners - Amish Country - Costa Rica - Expedition Michigan (or not) - Tellico Plains
The Toad is offline   Reply With Quote