View Single Post
Old 11-09-2012, 10:48 AM   #18
gunnerbuck OP
Island Hopper
 
gunnerbuck's Avatar
 
Joined: Nov 2005
Location: N.V.I, B.C.
Oddometer: 3,819
Well, I found why the bike was stuck at half throttle... The fault goes with the motion pro cables... It turns out the cable is too short, more specific there is not enough cable end free of the sheath... So when it is put in place the throttle cam has a little tension on it and lifts the slide.. The sheath is set as short as possible and the cable end is still 3/8" too short so I will try to trim a bit off of the sheath to buy some more length on the cable exposure...

I have heard some complaints about motion pro cables, this is my first trial on one and so far I say they suck....

gunnerbuck screwed with this post 11-09-2012 at 05:06 PM
gunnerbuck is offline   Reply With Quote