View Single Post
Old 11-10-2012, 08:45 PM   #8
sorebutt
Beastly Adventurer
 
Joined: Jun 2008
Location: Lewiston,ID
Oddometer: 1,562
Quote:
Originally Posted by troidus View Post
I once went to a local steel supplier to see about getting some sheet metal. I was thinking 18ga or so, something I could bend over a wood form with a mallet. I found out that what they call sheet metal starts at 1/4" and goes up.
That isn't sheet metal. That is plate. You measure sheet metal by gauge. You measure plate by inch or mm.
sorebutt is offline   Reply With Quote