View Single Post
Old 11-11-2012, 04:48 AM   #11
Bloodweiser OP
honestly
 
Bloodweiser's Avatar
 
Joined: Sep 2007
Location: way over yonder in the minor key
Oddometer: 2,573
The sheets I'm using are about 1/16" I guess. (Does that make it 16ga?)
Just had it lying around so I'm not sure.
I say kinda thick, because cutting it with a hacksaw isn't fun.

I'm shooting for garage good.
Close tolerances need not apply.
The rectangle should be easy enough.
But the circle does need to be a circle.

Flycutter or hole saw?
What can be used with just a handheld drill and get decent results?
Bloodweiser is offline   Reply With Quote