View Single Post
Old 11-15-2012, 08:55 AM   #3
Splisken
I'm not dead yet...
 
Splisken's Avatar
 
Joined: Oct 2011
Location: Drake, Colorado
Oddometer: 127
Hi Thanks for the write up. I own Fastway Evo2 pegs for my EXC and agree that they build quality equipment. I have been pondering these Adventure pegs for my SE but I would need to mount them in the "LoBoy" position. Would you be able to add any information on how well they fold in this position or how much lower they sit? My EVO2s dropped my feet roughly .75" at least in practical leg position if not actual vertical height. I measured it at my knee vs the tank while sitting on the bike.

It appears from the pictures that you are using the "LoBoy" position is why I ask...

One additional tip...I believe the springs are intended to go inside the frame mount (I notice you have the top over/on the mount). You will avoid a lot of wear on the frame mount by squeezing it inside and get a bit more resistance from the spring...at least if it works the same as the EVO2s.

Splisken screwed with this post 11-15-2012 at 09:01 AM
Splisken is offline   Reply With Quote