View Single Post
Old 11-17-2012, 01:33 PM   #35
ME 109 OP
Beastly Adventurer
 
ME 109's Avatar
 
Joined: Jun 2009
Location: Albury Australia
Oddometer: 2,400
I have the baffles under the front bearings.
That's a good point about leaving the input seal out.
Are the inner and outer races that close, so as to be able to take the shim measurement from the centre? I understand why measuring from the centre would be more accurate tho'

I have a donor cover plate to use for measuring the shims however I'm measuring some differences in depth. I've measured three or four places around each hole and have found differences of perhaps ten thou.
I'll need to re-asses and see if it is bearing movement that is giving me the differences, or cover plate thickness.

I've measured my tranny cover plate and the individual pockets (when measured in three different places) are within one thou. All good there.

If I don't use a gasket, would the Three Bond silicone that I use for barrel bases be suitable?
__________________
Lord of the Bings, kangaroo farmer
ME 109 is online now   Reply With Quote