View Single Post
Old 11-20-2012, 06:25 PM   #54
mark1305
Old Enough To Know Better
 
mark1305's Avatar
 
Joined: Feb 2005
Location: Merritt Island, FL
Oddometer: 5,968
Quote:
Originally Posted by Airhead Wrangler View Post
Know any machinists?

There is one other way to do it without a shim plate. I made a shim plate to that drawing, but my mill let me down and i couldn't get parallel faces on the plate. Check out my thread on a Tale of Two Transmissions. Specifically start at post # 38 i believe to see the depth gauge bridge i machined after the plate job failed. http://www.advrider.com/forums/showt...=435511&page=3

Many thousand miles later and the transmission still shifts better and is happier than the original box.

Feel free to PM with any questions.
__________________
Mark J
Merritt Island, FL

When a person asks you for advice, they don't want advice. They want corroboration.
mark1305 is offline   Reply With Quote