View Single Post
Old 11-21-2012, 07:10 PM   #36
CosentinoEngineering OP
Gnarly Adventurer
 
Joined: Oct 2010
Location: NYC
Oddometer: 183
TPS brackets ready to go

Just finished machining the first run of throttle position sensors for the FCR carbs. These brackets are a universal fit and will work on KTM, SV650 and other V twin varb configurations. The sidedraft side by side FCR configuration already comes with TPS mounting features so this kit enables use of a TPS on all FCR carbs.







The 2 piece kit requires 2 holes to be drilled in the throttle cable mounting bracket as shown in the following picture. A drill template will be included with the kit, as will all required hardware.



The shaft adaptor piece is machined from stainless steel and sits around the existing cable pulley. The 2 cone point set screws engage the hollow spring pin that holds the cable pully on to the throttle shaft. This keeps the part concentric on the throttle shaft and prevents binding.





The TPS sensor will need to be calibrated unpon installation, following the standard KTM procedure will work fine. Sakurama, how did you end up calibrating yours?

In the next few days my website will be revised to include an online shopping card for placing orders for the any of the various upgrades and also for complete carb kits with everything pre-installed.

Hope everybody has a happy Thanksgiving. Don't forget to increase spring preload for the post-feast ride!
__________________
Chris
moto2-usa.blogspot.com
Check out my products 10% off for ADV rider members
CosentinoEngineering is offline   Reply With Quote