View Single Post
Old 11-22-2012, 09:45 AM   #372
craydds
Beastly Adventurer
 
craydds's Avatar
 
Joined: Aug 2010
Location: Las Cruces, NM
Oddometer: 1,127
Quote:
Originally Posted by mrfortynine View Post
Hello, I hooked up acwell on my 92 R100R today. Have two quick questions.

1. The RPM ratio setting should just be default setting 1, right?

2. Since the fuel level wire is not connect to anything, it keeps flashing low fuel level on the display. Somehow it really annoys me. Is there anyway to trick the fuel level indicator to display a higher fuel level so that it would stop flashing?

Thanks.
1. Yes, rpm setting is "1". When you run the bike, check your tach, should read correctly. You can always change the setting if needed.
2. On the Acewell set-up, you should be able to turn the fuel level to OFF. Go through the set-up sequence until you get to the fuel indicator, and set it to OFF. I have my Acewell papers here with me so I'll review this and get back to you.
__________________
ABC #12947
'75 R90S
craydds is offline   Reply With Quote