View Single Post
Old 11-22-2012, 06:51 PM   #8
gettinold OP
n00b
 
Joined: Feb 2012
Location: Indiana
Oddometer: 5
Yea I removed the plastic and spring, used 10 different solvents and the like and nothing. I ended up using a number 7 drill bit to drill a hole about 3/8" into the plug then used a 1/4"-20 bottom tap and put some threads in the plug. I then screwed in a 3" s.s. hex head 1/4"-20 bolt into the plug, and after an hour of pulling on the bolt then tapping it in, went back and forth till it finally came out. The plug looks like it fused to the inside of the carb.
gettinold is offline   Reply With Quote