Thread: Engine Tool
View Single Post
Old 11-22-2012, 08:25 PM   #3
Head2Wind's Avatar
Joined: Mar 2006
Location: NorthWet Washington
Oddometer: 2,606
Drill bit or machined shaft to fit the hole to lock out the lash take up works as Kamanya states. One thing to keep in mind here is it is MUCH easier to put the lock pin in place while the gear set is mounted to the shaft than after the fact... Major PITA to reload the spring and then lock it out with the pin.
“The mind is sharper and keener in seclusion and uninterrupted solitude. --- Be alone, that is the secret of invention; be alone, that is when ideas are born.” - Nikola Tesla
2006 KTM 970 frankinADVsmSD
ADVmachines™ Proven Solutions for your Worldwide
Head2Wind is offline   Reply With Quote