ok did some more work on my setup today
first added the computer protector:
fits just over the mask:
fuzeblock will fit here ...just (with 17mm bar risers):
but its tight
and a little exposed through here:
wire up the switches and leds
and it looks like this with the std cable lengths: btw it weighs 350g like this:
back on the bike:
with the connectors on the std length cables the fuzeblock doesnt fit nicely anymore, it would be ok if i raised the bars higher but that wont be good for me ergonomically, attached to the back of the mask fits but it is tighter than i would like so i think i may have to move the mask forward, i've emailed paul at hdb to ask about the kit lukas has but no reply as yet. The brake hose has had to come out of its guide by the bottom triple clamp, moving the mask forward might make that worse so i may have to get a longer brake hose as i was planning on using a wolfman carry all on the mask, i'll wait and see about both of those though