View Single Post
Old 11-28-2012, 08:37 AM   #175
Baja Dad
Beastly Adventurer
 
Baja Dad's Avatar
 
Joined: Jan 2011
Location: Norco California
Oddometer: 1,830
Quote:
Originally Posted by schattat View Post
Indeed, that's exactly what you're after (like I said, same principle as with the buttons). What you need to do is, once you splice to connector (or leave it alone and use an opposite connector) check which of the 2 wires is signal (should be high at around 3-5V) and which is GND. Connect both signals together each with a diode (anodes to the signal line, cathodes together meet with the one line of the sensor). The 2 GNDs and the other end of the sensor all come together then!

What I need is someone to make me TWO spliters( for two bikes)
So I can Run a RSN and an ICO for back up .
If you can do this I would buy an RSN and do many hours of testing over this next month.
I see running multiple magnet pickups and cabels from the front wheel is a PAIN in the ASS!!
__________________
2014 support: GPR,IMS Aurora Rally Kriega, Raiden LS2,100Goggles,SIDI,Seat Concepts, Rally Raid Products UK,Precision Concepts, MX1West,Dunlop
Baja Dad is offline   Reply With Quote