View Single Post
Old 12-01-2012, 06:44 AM   #151
runnin4melife OP
Studly Adventurer
 
Joined: Mar 2012
Location: Maryland (I hate DC traffic)
Oddometer: 801
I am not that skilled for a rim, let alone do I have the equipment, plus I doubt it would last very long given the way I ride. I have been up since 5am working on the rad guard. It was a pain in the butt getting off the mold (used a bit too much resin, but better than not enough). I had to do a lot of clean up on this piece because the lay up was difficult to get setup but that is alright, my dremel and I have become inseparable today. Here it is right now, I want to sand some more before I clear coat it. This will clip in right in front of the stock rad guard so I have double the protection (important due to the high fender mod).




Photobucket


Photobucket


This thing is a springboard for rocks! It is 3 layers in a weave fashion of 5.7 oz w/HTE. It is super strong, I could sand some more to get it to look super pretty but it is a radiator guard...

runnin4melife screwed with this post 12-01-2012 at 09:31 AM
runnin4melife is offline   Reply With Quote