View Single Post
Old 12-03-2012, 04:01 AM   #3
cleatusj OP
Dirt floor engineer
 
cleatusj's Avatar
 
Joined: Dec 2010
Location: Granbury, TX
Oddometer: 1,100
Thanks Pete, I've read that and most every other thread on this and several other sites many times. I was hoping to keep some ground clearance but that will be reduced as it has been proven to me the reason to be centered with the pivots.

I will not have to rework the main frame as the axle mount is clamped on at this time. I will be loosing the center stand so that the rear mount can move toward center and the front bracket will en-circle the fowrard facing oil filter.
__________________
In the stable now. '76 Moto Guzzi Convert Hack
'93 Moto Guzzi Calli 3 with Leaner turned rigid

Hack build: http://www.advrider.com/forums/showt...rt+floor+build
cleatusj is offline   Reply With Quote