The EE's have the seals (covers) on both sides too. You can use a pick screwdriver to pry the seals off without damaging them. For the heim joint bearing make sure you get a straight shot when banging the seal in on the chain side. I left my chain and slider on replacing mine and messed up the seal on that side since I came in banging it at an angle. Looks like you already have your slider off though.
Quote:
Originally Posted by akarob
I got the KTM ones. They are sealed on both sides. On a good note, I pressed out the swingarm bearing without issue today at work. That sucker was in tight too. It would budge with the hand arbor press, so I put a few tons on it. Pushing the button was easier too.
 |
__________________
Darius
'06 KTM 400 EXC
If it wasn't for all the rocks, roots, trees, hills, mud, ruts, logs, sand, and lack of tar, I'd be a damn good off-road rider!
Darius on Dirt
|