View Single Post
Old 12-04-2012, 02:00 PM   #14
tofgasp
Adventurer
 
tofgasp's Avatar
 
Joined: Mar 2008
Oddometer: 58
Your seals are not upside down. As stated above, you might have an alignement problem of your stanchions wich is quite common on these forks.
The sliders are not guided as well as in the early models, but just by one teflon ring and 2 small o-ring. You must absolutely reassemble the fork in a specific order otherwise the fork brace twist the tubes, same as the wheel axle, if you tighten the lage bolt before the ones on the sliders, they lightly bend.
tofgasp is offline   Reply With Quote