View Single Post
Old 12-04-2012, 02:56 PM   #38
Beastly Adventurer
SCflyer's Avatar
Joined: May 2007
Location: Back in NC
Oddometer: 1,657
Just got my tank today, anodized black. Craig made a change and has small "keepers" made into the tank that the fuel hose goes through so it doesn't sag.

Few questions...

1. What size/length of fuel hose are you folks using to tie into the front tanks?
2. What fitting are you using to tie in?
3. What sealant are you using to seal up the nipple that goes on the "exit" at the front?
4. Can someone clarify what the purple hose in the kit is for? (Put on the cap?)

Again - quality build, light and out of the way but a run-down of extra pieces needed and some how-to of plumbing it into the the system would be nice. I'll do more reviewing of posts and pics but anything to add would be helpful for the 990 newby.

"Not all those who wander are lost" J.R.R. Tolkien
SCflyer is offline   Reply With Quote