View Single Post
Old 12-05-2012, 07:52 AM   #49
marksbonneville OP
Studly Adventurer
 
marksbonneville's Avatar
 
Joined: May 2008
Location: Arizona, Prescott more less.
Oddometer: 960
Quote:
Originally Posted by bagpiper22 View Post
I was going to go that route, but then figured with a puller on the way, I'd just wait. If I end up baking it, do you recommend a certain temp? For how long?

It's just the right hand side of the case, with the crank. Oil pump is still attached. I have an old baking sheet in my shop I can put the case in. Maybe baste it with a nice little 5W-30? Ha!

Thanks,

Scott

Remove the oil pump as you might as well replace the gasket anyhow. I put mine in the oven at 250 but the crank and bearing fell out before that point, the pinion tool was a waste of money for me, could not hold up to the pressure. Make sure you post pics of the parts in the oven if the wife or girlfriend sees them.
marksbonneville is offline   Reply With Quote