View Single Post
Old 12-05-2012, 03:44 PM   #178
runnin4melife OP
Studly Adventurer
 
Joined: Mar 2012
Location: Maryland (I hate DC traffic)
Oddometer: 803
Sorry I couldn't help myself with this. I wanted to test out the piece so here is my first go at it..... Since I created the fiberglass model I wound up with a predicament in that I have a gap between the stock fairing and guard. If I do no like how this piece comes out I will fill in the gap and then use this as the mold for the final piece. I have made 6 fiberglass pieces leading up to this as well as I made paper mache when starting from scratch. I will not lie that this was difficult but none the less it was a lot of fun!

I have some trimming I still need to do to it. After I pulled it out of the mold I couldn't get a test fit to the gas tank/subframe because it is still too wide (left too much over hang on the piece).







runnin4melife screwed with this post 12-06-2012 at 06:18 AM
runnin4melife is offline   Reply With Quote