View Single Post
Old 12-05-2012, 09:59 PM   #5723
dorkpunch
Oops...
 
dorkpunch's Avatar
 
Joined: Aug 2006
Location: Blackfoot, ID
Oddometer: 4,992
Yeah, I know... it doesn't "qualify"... But I would like some suggestions on the tank. Its obviously way to tall, so I am going to knock an inch of the top and almost two off the bottom, shown in the last pic.









The seat will be cut way down and a bump put on the back. Planning on trying to make the first one out of cold rolled, but I would like to make one out of aluminum eventually with radiused edges. Got a sheet of al. to mess around with but that'll probably come much later. It's ugly.
__________________
http://www.mobilemrt.com http://www.dorkpunch.com

"I've been going to this high school for SEVEN YEARS. I'm no dummy!"
-Charles De Mar.
dorkpunch is offline   Reply With Quote