View Single Post
Old 12-08-2012, 08:15 AM   #49848
ThumpnRed
Pig Wrangler
 
ThumpnRed's Avatar
 
Joined: Aug 2009
Location: Eye Duh Hoe
Oddometer: 2,296
Quote:
Originally Posted by bp_josh View Post
How complicated is it to take the swingarm off and put it back on? Will I have to wrestle with the rear shock (compress it or something) to reassemble it? My bike lift is a floor jack with a piece of wood on it to go under the bash plate.

If I do take it off, I assume I should either re-grease or replace a couple parts while I'm in there right? What will need attention?

I want to paint it, but I'm trying to decide if it's worth the hassle.
It is not that big of a deal and you should take everything off once in a while to clean and check all of the bearing. You'll want to take off the tank (to get to the seat) and the seat to make it possible to get to the upper shock bolt.
I did a how-to thread over on TT about removing the shock. http://www.thumpertalk.com/topic/945...l#entry9885700 It will give you an idea of what it involves. Bear in mind, you dont have to remove the shock, but I would just to clean and inspect everything. At the end my series of picture on the htread, you would only be left with loosening and removing the swingarm bolt.
__________________
Quote:
Originally Posted by Cigar Mike :With plastic buy two.
'93 XR650L A few stock parts left...
ThumpnRed is offline   Reply With Quote