View Single Post
Old 12-09-2012, 03:34 AM   #17
bushyb OP
Adventurer
 
bushyb's Avatar
 
Joined: Apr 2012
Location: Rotorua, New Zealand
Oddometer: 74
Quote:
Originally Posted by cycleman2 View Post
Sometimes people get the atomizer in backwards after a carb rebuild. The bike will run but not well as its not getting enough fuel. Also check that both cylinders exhaust is generating heat.
Thanks, not quite sure of the comment above but you might be onto something. I removed the left carb and on removing the main jet and nut the needle jet just fell out but the atomizer remained in place. Now I am not sure that this would cause the problem that I have as the main jet when screwed in would hold the needle jet in place. Any ideas on how to remedy this? Thanks
bushyb is offline   Reply With Quote